Mk23 follower type short e.s. custom works (escw-32)

BRAND E.S. CUSTOM WORKS

ESCWorks presents the brand new Follower extension (type short) for Marui MK23 magazines and clones.

Follower push ball that facilitates the experience of the player, allows to lower the push ball very easily, simplifying the operation even if it uses gloves thanks to its elongated design that protrudes the pin of a few MM from the loader itself.

The TYPE SHORT version resumes unlike its original counterpart is shorter than about 10mm, this allows you to accumulate more BBS inside the charger (about 3bbs)

N.B. Depending on the loader you have, you MUST SPECIFY THE PRESENCE OF THE RIGHT SLIDE SIDE FIN !!!!!!
No. 2 DUE TO NON-CALCULATED TOLERANCES FOR VARIOUS REASONS (LOADER WEAR, LOADER BRAND, WEAR SPRING WEAR SAME. IN SOME CASES YOU MAY NEED FOR AN OPTIMAL SLIDING, GIVE A SMOOTH SMOOTH TO THE PART WITH FINE SHEET.